CONNECTION
(1) Connecting the Output Terminal (LINE OUT)
Use the included pin cords to connect the left (L) and right (R)
output terminal (LINE OUT) of the DN-60OF to the CD, AUX, or
TAPE PLAY left (L) and right (R) input jacks of the amplifier.
Connection Precautions
Before proceeding with connections or disconnections of cables
and power cords, be sure to turn all system components off.
Ensure that all cables are connected properly to the L (left) and R
(right) jacks.
Insert plugs fully into the terminals.
• Connect the output jacks to the amplifier CD, AUX or TAPE
PLAY input jacks.
OPENING AND CLOSING THE DISC HOLDER AND LOADING A DISC
Opening and closing the disc holder
(This operation only works while the power is on.)
1. Press the power switch (POWER) to turn on the power.
2. Press the open/close button (OPEN/CLOSE).
How to load a disc
Make sure the disc holder is completely open.
Hold the disc by the edges and place it on the disc tray. (Do not
touch the signal surface, i.e., the glossy side.)
• When using 12 cm diameter discs, make sure the outer edge
matches the tray guide circumference (Fig. 1), and when using CD
singles (8 cm diameter) match the outer edge with the inner tray
guide circumference. (Fig. 2)
Press the open/close button (OPEN/CLOSE) to close the disc
holder.
• When the disc holder is closed, the disc is read and after a few
seconds the number of tracks and total playing time are displayed
on the TRACK NO. and TIME displays, respectively.
• When the disc holder is open and a disc is loaded, you may also
press the play or pause button to close the disc holder. (If the play
button is pressed, playback will start immediately upon the disc
contents having keen read.)
(2) Connecting the Digital Output Jack (COAXIAL)
Use a 75 0 /ohm pin cord to connect the digital output jack
(COAXIAL) of the DN-60OF to the digital input jack (COAXIAL)
on a digital processor or D/A unit, available in stores.
Caution:
If your finger should get caught in the disc holder when it closes,
press the open/close button (OPEN/CLOSE).
• Do not place any foreign objects on the disc tray, and do not
place more than one disc on the tray at a time. Otherwise
malfunction may occur.
• Do not push in the disc tray manually when the power is off as
this may cause malfunction and damage the CD player.
To Next Page
Loading...
Need help?
Audio Functions and Display
