ENGLISH
44
11
ADJUSTING THE PICTURE QUALITY
1
3
Use the 0 and 1 cursor buttons to select the picture
memory, then press the ENTER button.
• The display switches as follows:
STD (STANDARD) ´ M1 (MEMORY 1) ´ M2 ´
M3 ´ M4 ´ M5
STD (Factory default)
When this is selected, both the picture quality and
function are reset to factory setting.
M1 ~ M5
Picture quality settings you have adjusted can be
stored here.
Select the item to change using
0 and 1 buttons.
ADJUST MODE
• The contrast, brightness, sharpness and color (HUE)
can be adjusted.
• Perform steps 4 ~ 6 to adjust the picture quality
(ADJUST MODE).
GAMMA
• Select this if dark portions of the picture are too dark
or bright portions are too bright.
• Perform steps 7 ~ 9 to adjust the gamma correction
(GAMMA).
Remote control unit
2
4
Press the ª cursor button to select the adjust mode,
then use the
0 and 1 cursor buttons to select the
image quality adjustment item.
CONTRAST (-6 ~ +6)
Adjusts the contrast of the image.
BRIGHTNESS (0 ~ +12)
Adjusts the picture’s brightness.
SHARPNESS (-6 ~ +6)
Adjusts the sharpness of the picture.
HUE (-6 ~ +6)
Adjusts the balance of the green and red. (This does
not affect Progressive Scan images and the component
video out.)
To Next Page
Loading...
Need help?
General
