4. Service region settings update procedures
Copy the Service Region Settings from the USB ash drive to this unit.
4.1. Items to Be Prepared
・ Windows PC
・ USB ash drive format : Prepare a USB ash drive formatted in FAT16 or FAT32.
NOTE:
・ Do not run the USB ash drive through a hub.
・ Do not connect a computer to the USB port of this unit using a USB cable.
・ Do not use an extension cable when connecting the USB ash drive.
・ If a USB ash drive cannot be updated, replace it with a different USB ash drive and perform
the update again.
4.2. Creating a Service Region Settings le
(1) Click [Start button] - [Accessories] - [notepad] on the PC to launch the notepad.
(2) Enter "
TEXT
".
(3) Click "File", and then click "Save As...".
(4) Enter the le name and click the Save button.
NOTE : Enter the le name in double quotation marks. (The le extension is not required.)
Service Region File name
North America "denon-cong-locale-set-1"
Europe "denon-cong-locale-set-2"
Japan "denon-cong-locale-set-3"
Australia "denon-cong-locale-set-4"
Korea "denon-cong-locale-set-5"
China "denon-cong-locale-set-6"
Israel "denon-cong-locale-set-7"
(5) Copy the les created on the USB ash drive.
4.3. Inserting a USB ash drive in the USB port
(1) Insert a USB ash drive containing the le created by the above procedure into the USB port on the
back panel of this unit.
(2) Check that the LED on the front panel of this unit is blinking, then remove the USB ash drive from
this unit.
The Service Region Settings are now complete.
copy to USB flash drive
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
53