ELITEPRO XC™ TECHNICAL SPECIFICATIONS
Specification Description
Service Types
Single Phase-Two Wire, Single Phase-Three Wire, Three Phase-Four Wire
(WYE), Three Phase-Three Wire (DELTA), DC Systems (solar, battery)
Voltage Channels 3 channels, CAT III, 0-600 VAC (line-to-line) or 600 VDC
Current Channels 4 channels, .67 VAC max, +/- 1 VDC max; ideal for 333 mV full scale CTs
Maximum Current
Channel Input
Voltage
External transducer dependent; 200% of current transducer rating (mV
CTs); Measure up to 6000A with RoCoil CTs
Measurement
Type
True RMS using high-speed digital signal processing (DSP)
Line Frequency DC/50/60Hz
Waveform
Sampling
12 kHz
Channel Sampling
Rate
(internal
sampling)
200 samples/cycle at 60Hz
240 samples/cycle at 50Hz
Data Interval
The default integration period is fifteen minutes. The choices are 1, 3,
15, 30 seconds; 1, 2, 5, 10, 15, 20 and 30 minutes; 1 and 12 hours; 1 day.
This tells the logger at what time intervals data is to be stored in the
memory. For example, if the integration period is set for 30 minutes and
average watts is being monitored, then every 30 minutes the logger
records the average power use (watts) for that channel over the
preceding 30 minute interval, based on approximately 14,400
measurements of the monitored power draw. If Maximum (and/or
Minimum) values are being recorded the highest (and/or lowest) of
those 14,400 readings are also saved.
Energy
Measurements
Volts, Amps, Amp-Hrs (Ah), kW, kWh, kVAR, kVARh, kVA, kVAh,
Displacement Power Factor (dPF). All parameters for each phase and for
system total.
1
Analog
Measurements
0–10 Volts, 0 or 4–20 ma current loop non-isolated, external power for
current loop. User scaling for sensor reporting in physical units.
Accuracy Better than 1% (<0.5% typical) for V, A, kW, kVAR, kVA, PF
2
Resolution 0.01 Amp, 0.1 Volt, 0.1 Watt, 0.1 VAR, 0.1 VA, 0.01 PF, 0.01 ANA
To Next Page
Loading...
Need help?
General
