9
ENGLISH
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing thisprocedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into aliquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by
, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only
recommended
accessories should be used with thisproduct.
WARNING: These chisels can be reground only a
limited number of times. If in doubt, contact your dealer
forrecommendations.
WARNING: Ensure that the cutting edge does not show
discolouration caused by too much pressure. This may
impair the hardness of theaccessory.
Accessory Maintenance (Fig. G)
Accessory maintenance at the right time guarantees optimal
results in application and a long and efficient accessorylife.
Grind the chisels on grinding discs. Refer to FigureG for the
appropriate angles of the following chisels:
7
Pointed chisel
8
Cold chisel
10
Spade-shaped chisel
Consult your dealer for further information on the
appropriateaccessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
householdwaste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
To Next Page
Loading...
Need help?
General
