Digi ConnectPort LTS 8 User Manual

ConnectPort LTS features IP protocol support
Digi ConnectPort LTS User Guide
13
n Line Printer Daemon (LPD)
n Remote login (rlogin)
n Remote shell (rsh)
n SNMP
n Telnet
n Secure Shell Server (SSH)
You can enable or disable access to network services from the Network ServicesSettings page in the
web interface. For more information, see Basic Network Services Settings.
You can use the set service command to enable and disable network services from the command-line
interface. See the Digi Connect® Family Command Reference on www.digi.com for a description of the
set service command.
IP protocol support
All ConnectPort LTS devices include an on-board TCP/IP stack with a built-in web server. Supported
protocols vary by specific product and include, unless otherwise noted:
n Transmission Control Protocol (TCP)
n User Datagram Protocol (UDP)
n Dynamic Host Configuration Protocol (DHCP)
n Simple Network Management Protocol (SNMP)
n Secure Sockets Layer (SSL)/Transport Layer Security (TLS)
n Remote login (rlogin)
n Line Printer Daemon (LPD)
n HyperText Transfer Protocol (HTTP)/HyperText Transfer Protocol over Secure Socket Layer
(HTTPS)
n Simple Mail Transfer Protocol (SMTP)
n Internet Control Message Protocol (ICMP)
n Internet Group Management Protocol (IGMP)
n Address Resolution Protocol (ARP)
n Advanced Digi Discovery Protocol (ADDP)
Serial data communication over TCP and UDP
ConnectPort LTS products support serial data communication over TCP and UDP. The key features
include:
n Serial data communication over TCP can automatically perform the following functions:
l Establish bi-directional TCP connections, known as autoconnections, between the serial
device and a server or other network device. Autoconnections are based on data and/or
serial hardware signals.

Digi ConnectPort LTS 8 Specifications

General

Brand	Digi
Model	ConnectPort LTS 8
Category	Server
Language	English