Digi ConnectPort LTS 8 User Manual

Configure and manage the device using the ConnectPort LTS
command line interface
Management through the command line
interface
Digi ConnectPort LTS User Guide
136
n Serial statistics. The info serial command displays the following information:
l Number of bytes received and transmitted
l Signal changes
l FIFO and buffer overruns
l Framing and parity errors
l Breaks detected
n TCP statistics. The info tcp command displays the following information:
l The number of segments received or sent
l The number of active and passive opens
l The number of bad segments received
l The number of failed connection attempts
l The number of segments retransmitted
l The number of established connections that were reset
n UDP statistics. The info udp command displays the following information:
l The number of datagrams received or sent
l The number of bad datagrams received
l The number of received datagrams that were discarded because the specified port was
invalid
n ZigBee statistics. The info zigbee_sockets command displays the following information:
l The number of frames received or sent
l The number of bad frames received or sent
l The number of bytes received or sent
l The number of received bytes dropped or truncated
newpass
Use the newpass command to issue a new password to a user.
reconnect
Use the reconnect command to reestablish a connection opened by a connect, rlogin, or telnet
command. By default, the reconnect command reestablishes the connection to the last active
session.
rlogin
Use the rlogin command to sign in to a remote system.
send
Use the send command to send a telnet control command, such as break, abort output, are you there,
escape, or interrupt process, to the last active telnet session.

Digi ConnectPort LTS 8 Specifications

General

Brand	Digi
Model	ConnectPort LTS 8
Category	Server
Language	English