DVM-500Plus Installation Guide 002-0501-02 REV C Page 8
SYSTEM INSTALLATION
The current factory rearview mirror must be removed from the windshield mounting plate. There are several
versions of mirror mounting systems. Below are the most common methods of rearview mirror removal. Do
not use excessive force when removing the mirror from the windshield. The mirror mounting plate may
become separated from the windshield and/or the windshield may break if excessive force is used.
Use one of the following methods below that matches the mirror mounting configuration of your vehicle:
1. Using a Philips screwdriver or #20 Torx bit, loosen the screw in the base of the mirror.
2. After loosening the screw, gently lift upward to slide mirror off of mirror mount.
2011-2012 Dodge Charger Rearview Mirror Removal
1. With your right hand, grip the mirror and keep it stabilized.
2. With your left hand, grip the base of the factory mount where it meets the glass.
3. Gently apply a small amount of additional inward force toward the glass and rotate the base
clockwise.
4. The spring loaded factory mount should release from the windshield puck. See picture Below.
1. Remove front passenger side threshold
To Next Page
Loading...
Need help?
General
