22
EDITING A MODULE
Your 2112 comes loaded with pretty much all of the Factory Effect Defaults you’ll need right at your finger tips. In any
given situation, however, you may want to tweak a module just a tad (or more than a tad).The parameters of each
Effect Module are reached through a series of pages.
• Press the <Edit> button.The display looks something like this:
When you first enter FX Edit mode (by pressing the <Edit> button), you are taken to the Tube distortion module in
the Preamp section.
T
urn the <Program/Effect> wheel to scr
oll thr
ough the modules until y
ou reach a digital Eff
ect
module. Notice that as you scroll through the different modules, the currently selected module will flash in the Effect
Routing Matrix.
Once you ha
v
e reached a module in the Digital Eff
ects section that y
ou want to edit,
use the <Page>
knob to scroll to the particular parameters.
Notice: Anytime a change is made to either an Effect Module or Default, the
Changed
icon will appear
directly below the effected parameter within the module or default.
S
CROLLING THROUGH A
MODULE’S PAGES
Notice in the bottom left corner of the display (just under the Program Number) the display indicates which page you
are on and the total number of pages within the module. Each page allows you to access up to four parameters using
the <1> - <4> knobs.
EXAMPLE:
To scroll through the parameter pages of the Quad Chorus module, from the Program mode either press the
<Mod> button on the front panel until the Quad Chorus module comes up in the display. or, press the <Edit>
button and once this button is lit, use the Program/Effect wheel to scroll to the Quad Chorus module.At this
point use the <Page> button to scroll through the parameters of the Quad Chorus module.
For a description of all the FX Modules and their parameters, see pages 23-27.
To Next Page
Need help?
General
