23
GLOBE - IP1839
GB
Problem Possible cause Remedy
The automation does not open
and close.
No power. Check that
the control panel is on (the POWER
ALARM led must be on).
Accessories in short circuit.
(LED POWER ALARM flashing)
Disconnect
all the accessories from the terminals
0-1 (24 V= are required) and reconnect these one
at a time.
Line fuse burnt out. Replace the fuse F1.
The stop contact is open Check terminal 9 of the control panel
The
automati
on opens but does
not close
The safety contacts are open.
(LED SA on).
Check terminal 8 of the control panel.
The photocells (if fitted) are triggered.
(LED SA
on).
Make sure the photocells are clean and working
properly.
Automatic closing does not work. Check the setting of the
TC trimmer
The automation fails to open.
The automation
is closed and the photocells (if
fitted) are operative.
(LED SA on).
Make
sure
the photocells are clean and working
properly.
See jumper SO.
Remote control does not work. M
a
ke sure the transmitters have been properly
stored on the built-in radio receiver. In case of
f
ailure of the radio receiver built in the control
panel, the remote control codes can be accessed
by extracting the memory module.
C
ommand devices faulty or connections
interrupted.
Ch
eck opening by means of jumper 1-5 of the
terminal board control panel.
The external safety devices (if
fitted) fail to operate.
Wrong connections between the photocells and
the control panel
Co
nnect the N.C. safety contacts together in series
and remove any jumpers on the terminal board of
the control panel.
The automation
opens/closes
for a
short distance and then
stops.
Encoder faulty
.
(LED POWER
ALARM flashing).
Replace the encoder.
Motor leads reversed.
(LED POWER
ALARM flashing).
Check the motor leads.
There are frictions. Ma
nually make sure the automation is moving
freely.
Encoder not connected. Check the connection.
False encoder contacts. Clean the
contacts by engaging and disengaging
the encoder plug on the contacts.
R1 set too low. Check R1 adjustment.
The radio
remote control has a
low range and does not work
with the automation in motion.
R
a
dio transmission is hampered by metal
frameworks and reinforced concrete walls.
Install
the
antenna outside. Replace the batteries
of the transmitters.
8. TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
