Operation CFX28 – CFX65DZ
14
Selecting the temperature units
Temperature display units can be switched between Celsius and Fahrenheit as
follows:
➤ Switch on the cooler.
➤ Press the “SET” button (fig. 3 4, page 11) twice.
➤ Use the “UP +” (fig. 3 7, page 11) or “DOWN –” (fig. 3 6, page 11) buttons to
select Celsius or Fahrenheit.
✓ The selected temperature units then appear in the display for a few seconds. The
display flashes several times before it returns to the current temperature.
7.2 Energy saving tips
•
Choose a well ventilated location which is protected from direct sunlight.
•
Allow warm food to cool down first before placing it in the cooling device to
keep cool.
•
Do not open the cooling device more often than necessary.
•
Do not leave the cooling device open for longer than necessary.
•
Defrost the cooler once a layer of ice forms.
•
Avoid unnecessarily low temperatures.
7.3 Connecting the cooler
Connecting to a battery (Vehicle or boat)
The cooler can be operated with 12 V or 24 V
g.
A
For safety reasons the cooler is equipped with an electronic system to prevent
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
NOTICE! Danger of damage!
Disconnect the cooler and other consumer units from the battery before
you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
CFX-28-CFX-65--O-EN-AUSv2.book Seite 14 Dienstag, 3. April 2018 8:42 08
To Next Page
Loading...
Need help?
General