CFX28 – CFX65DZ Operation
19
I
✓ The cooler starts cooling the interior.
I
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2 1, page 10) down, until it latches in place audibly.
I
7.6 Setting the temperature
➤ Press the “SET” button (fig. 3 4, page 11) once.
➤ Use the “UP +” (fig. 3 7, page 11) and “DOWN –” (fig. 3 6, page 11) buttons
to select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
I
NOTE
Displayed temperature
•
CFX28, CFX35W, CFX40W, CFX50W, CFX65W:
The temperature displayed is that of the large interior compartment
(e.g. CFX50W, CFX65W: fig. 7 1, page 18).
•
CFX65DZ:
– With fridge/freezer divider in: The temperature displayed is that
of the freezer compartment (fig. 8 1, page 18).
– With fridge/freezer divider out: The actual compartment
temperature will be considerably warmer than the displayed
temperature
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED “P” flashes orange.
NOTE – Lid Open Alarm
If the lid is left open for three minutes or more and the device is switched
on, the interior light will flash until the lid is closed.
NOTE
The temperature can be set to –22 °C. The manufacturer however rec-
ommends a cooling temperature of –15 °C to –18 °C for normal usage
and optimum energy consumption.
CFX-28-CFX-65--O-EN-AUSv2.book Seite 19 Dienstag, 3. April 2018 8:42 08
To Next Page
Loading...
Need help?
General