Operation CFX28 – CFX100W
16
7.3 Connecting the cooler
Connecting to a battery (Vehicle or boat)
The cooler can be operated with 12 V or 24 V
g.
A
For safety reasons the cooler is equipped with an electronic system to prevent
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
➤ Plug the 12/24 V connection cable (fig. 1 2, page 7) into the device
DC voltage socket and also into a 12 V or 24 V cigarette lighter socket.
Connecting to a 100 – 240 V AC mains (E.g. in the home or office)
D
The coolers have an integrated multi-voltage power supply with priority circuit for
connecting to an AC voltage source of 100 – 240 V. The priority circuit automatically
switches the cooler to mains operation, if the device is connected to a 100 – 240 V
AC mains, even if the 12/24 V connection cable is still attached.
➤ Plug the 100 – 240 V connection cable (fig. 1 3, page 7) into the device
AC voltage socket and connect it to the 100 – 240 V AC voltage mains.
NOTICE! Danger of damage!
Disconnect the cooler and other consumer units from the battery before
you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
DANGER! Danger of electrocution!
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your cooler on board a boat from a mains
connection of 100 – 240 Vw, you must install a residual current
circuit breaker between the 100 – 240 V
w
mains and the cooler.
Seek advice from a trained technician.
CFX-28-CFX-65--B-EN-AUSv1.book Seite 16 Montag, 14. November 2016 10:53 10
To Next Page
Loading...
Need help?
General
