Operation CFX28 – CFX100W
18
7.5 Using the cooler
A
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
➤ Connect the cooler, see chapter “Connecting the cooler” on page 16.
A
➤ Press the “ON/OFF” button (fig. 3 1, page 11) for between one and two
seconds.
✓ The LED “P” lights up (fig. 3 2, page 11).
✓ The display (fig. 3 5, page 11) switches on and shows the current cooling
temperature.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
NOTE
Place the cooler as shown (fig. 1, page 7). If you operate the box in a
different orientation it can be damaged.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
CFX-28-CFX-65--B-EN-AUSv1.book Seite 18 Montag, 14. November 2016 10:53 10
To Next Page
Loading...
Need help?
General
