– 6 –
START-UP
NEA1402
Turn on the refrigerator by pressing the ON/OFF key.
NDA1402
Before turning on the refrigerator, please verify that all
the manual gas valves, including the manual shut off
valve, are in the ON position.
Turn on the refrigerator by pressing the ON/OFF key.
1.
2.
SET DEFROST TIMER
NOTE! The defrost timer must be set in order for the automatic defrosting system to work properly. For further information, see
REFRIGERATOR OVERVIEW > AUTOMATIC DEFROSTING SYSTEM. If the defrost timer has to be set, the LED panel will show
flashing horizontal bars ” -- -- “.
To enter TIMER MODE keep SET key pressed until figures flash on the LED panel.
(Hours are to the left and minutes to the right.)
Press the SET key to adjust to local or Central American time. PM/AM should also be set here.
Store each setting by pressing AUTO key (NEA 1402) - AUTO/STORE key (NDA 1402) - or -
use the automatic store function (wait 5 sec.).
SET THERMOSTAT RANGE
NDA1402 temperature control
The freezer and the fresh food compartment temperatures are controlled separately and independently of each other, based on the
actual air temperature in each compartment. The compartment temperatures will be the same regardless of ambient temperature or
setting in the other compartment.
The freezer setting is pre-set (can not be changed) to be approx. 0F (-18°C) when running on AC.
If running on GAS the pre-set temperature is approx. 7F (-14°C).
The fresh food compartment can be set in 5 different positions (1-5) where 5 is the coldest setting which give a fresh food
temperature of approx. 33F (0°C). Setting 3 gives a temperature of approx. 37F (3°C).
Press the SET key to set the thermostat. Thermostat range is 1 to 5, where 5 represent the coldest compartment temperature.
Press the STORE key to store or use the automatic store function (wait 5 sec.).
1.
2.
3.
•
•
1.
2.
OPERATING INSTRUCTIONS
NEA1402 NDA1402
NEA1402 NDA1402
FIRE HAZARD. Before lighting the gas burner, after that the RV has not been used for some time, please
check that the gas path between the burner jet and the burner tube has not been obstructed. Failure to heed
this warning could cause a fire resulting in personal injury.
To Next Page
Loading...
Need help?
General
