Operation RC10.4 70, RC10.4 90
22
➤ To operate the refrigerator with a AC mains supply, use a CoolPower EPS100W
or MPS35 rectifier.
7.5 Mounting the refrigerator
!
I
Proceed as follows (fig. 0, page 9):
➤ Move the refrigerator into its final location.
➤ Fasten the four screws through the four plastic washers in the sides of the refrig-
erator into the wall (1).
➤ Put the caps onto the screw heads.
8Operation
I
8.1 Energy saving tips
•
Choose a well ventilated installation location which is protected from direct
sunlight.
•
Allow food to cool down first before placing it in the device.
•
Do not open the cooling device more often than necessary.
•
Do not leave the door open for longer than necessary.
•
Defrost the cooling device as soon as a layer of ice forms.
•
Avoid unnecessarily low temperatures.
•
Clean the condenser of dust impurities at regular intervals.
CAUTION!
Only drill through the washers provided, otherwise foamed compo-
nents, including cables, can be damaged.
NOTE
Attach the side walls or the attached strips so that the screws are tight,
even when under increased loads (while driving).
NOTE
Before starting your new cooling device for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter “Cleaning and maintenance” on
page 26).
RC10.4-IO-EN-DE-FR-NL.book Seite 22 Montag, 10. September 2018 11:15 11
To Next Page
Loading...
Need help?
General
