Manual energy selection / manual ignition
with battery igniter
4.3 Explanation of operating
controls
12
4.1 Cleaning
Before starting up the refrigerator, it is recom-
mended that you clean it inside and repeat this
at regular intervals.
Use a soft cloth and lukewarm water with a
mild detergent. Then wipe out the appliance
with clean water and dry thoroughly.
To avoid material alterations, do not use soap
or hard, abrasive or soda-based cleaning
agents. Do not allow the door seal to come
into contact with oil or grease.
4.2 Maintenance
The gas burner must be inspected and
cleaned as necessary at least once a
year. When using liquefied petroleum gas
(tank or refill cylinders) the maintenance
interval is reduced to half-yearly or quar-
terly.
Keep the evidence of maintenance work
carried out on your refrigerator.
Work on gas and electrical equipment
shall be carried out by qualified person-
nel only.
It is recommended that this is carried out by
an authorised customer services depart-
ment.
We recommend maintenance following an
extended shutdown of the vehicle. Please
contact our customer services.
4.0 Refrigerator operation
Refrigerator operation
1 = Power On switch / Energy selector switch
2 = Temperature controller
3 = Battery igniter (gas)
4 = Flame indicator (galvanometer)
Explanations:
The refrigerator is equipped to operate on
mains power, 12V DC or liquid gas. Select the
desired power supply by turning the energy
selector switch (1). The energy selector
switch (1) has four settings:
Off
Mains voltage (230V AC)
Direct-current voltage (Batterie, 12V DC)
Gas (liquid gas propane/butane)
Fig.7
2
1
3
4
The refrigerator is equipped to operate on
three power modes:
Mains voltage (230V AC)
Direct-current voltage (12V DC)
Gas (liquid gas propane/butane)
Each refrigerator with manual ignition is equip-
ped with an automatic flame safety valve
which interrupts the gas supply automatically
after approx. 30 seconds when the flame has
extinguished.
1
Fig. 6
Fig. 5
2 3 4
1
OFF
230V~
12V=
Gas