- 17 -
REFRIGERATOR REMOVAL
Refrigerator removal and installation should be
performed by a qualied service technician.
Before removing the refrigerator:
1. Verify that the 120 VAC power cord is discon-
nected at the rear of the refrigerator.
2. Verify that the 12 VDC leads are disconnected
and capped at the rear of the refrigerator.
3. Shut off the gas supply.
4. Disconnect and cap the LP gas line at rear of
refrigerator.
To remove the refrigerator:
1. Remove the screws anchoring the refrigerator
to the enclosure.
2. Slide the refrigerator out of the compartment.
To replace the refrigerator:
1. Make sure the sealing strips (isolating the ap-
pliance combustion system from the vehicle
interior) are properly positioned for a complete
seal.
2. Slide the refrigerator back into the compart-
ment.
3. Replace the screws anchoring the refrigerator
to the enclosure.
4. Reconnect the LP gas supply line at the rear of
the refrigerator.
Always use a backup wrench when loosing
and tightening LP gas connections.
5. Check all connections for LP gas leaks.
6. Reconnect the 12 VDC leads at rear of refrig-
erator.
7. Reconnect the 120 VAC power cord at rear of
refrigerator.
Always use a backup wrench when loosing
and tightening LP gas connections.
To Next Page
Loading...
Need help?
General
