33
THERMOSTAT REPLACEMENT
To replace the thermos tat,
remove capillary from its clamp on the fresh food
evaporator fins, Remove the two sealing plugs,
one on the outside and one on the
inside of the cabinet. Straighten the capillary and pull it through the cabinet,
Remove the thermostat by
mscrewing
it from the gas filter and the flame failure
safety device.
NOTE :
Always, shut off the gas supply before removing any gas part from the
refrigerator,
By-pass screw sizes and part No.
Mode
1
RM4
14
RM36C
517
RM46
,RM47
517
RM66
,RM67
s17
RM76
,RM77
s17
By-pass
screw
Part No.
34
19
13-14/3
17
28
19-02/l
17
28
19-02/l
1728
1+02/l
17
28
19-02/l
Therm0 couple
(Feylet
placed
l/3”
into flame)
15.
THE GAS BURNER (see fig. 55)
The burner has the jet horizontally
located and the burner mixing tube is
formed as a bend with vertical outlet.
The
pri<mary
air inlets are pre-set and
therefore not adjustable. The burner
and the burner holder are made in one
piece.
The burner is provided with the
thenno-
electric failure safety device and the
thermocouple tip is pre-set.
Fig. 54
Fig. 55
To check for a correct flame, set thermostat to
“!AX”.
Flame should have a bright
blue crown at the base of the
flame.
Burner jet sizes and input
BTU/h.
Mode
1
Butane
Part
Ko. Propane
RM24
24
28900
39-lG/6
24
RM36C
34
200
26
60-15/3
43
RM46,RM47
43
200
26
60-16/l’
51
RM66,@167
51
200
26
60-1719
52
RI176
,RM77
5 1
200
26
60-17/9
53
Part
Ko.
Input BTU/h
281)
00
35-10/6
600
290
26
60-1611
1000
200
26
60-1719
1100
200
36
60-1817
1200
200
26
GO-19/5
1360
To Next Page
Loading...
Need help?
General
