19
Troubleshooting
If the vacuum is not working properly, the screen display will show an error message.
Please refer to the troubleshooting table to nd your solution.
Error Icon Possible Causes Solutions
Clean the brush
Refer to the maintenance
guide [Cleaning the Soft
Roller Brush Bar] section to
clean the ber material and
hairs wrapped around the
roller brush.
Air duct blocked
Check whether the dust
bin, extension rod, and
soft roller brush bar are
blocked.
Error
Please contact our after-
sales service department
for maintenance.
Overheating
Please wait and continue
to use after battery
temperature is normal.
WEEE Information
A
ll products bearing this symbol are waste electrical and electronic
equipment (WEEE as in directive 2012/19/EU) which should not be mixed
with unsorted household waste. Instead, you should protect human
health and the environment by handing over your waste equipment to
a designated collection point for the recycling of waste electrical and
electronic equipment, appointed by the government or local authorities.
Correct disposal and recycling will help prevent potential negative
consequences to the environment and human health. Please contact the
installer or local authorities for more information about the location as
well as terms and conditions of such collection points.
EN
To Next Page
Loading...
Need help?
General
Weight and Dimensions
