20 21
EN EN
Specications
This product contains batteries that can only be replaced by qualied technicians or
after-sales service.
This product contains batteries that are non-replaceable.
All products bearing this symbol are waste electrical and electronic
equipment (WEEE as in directive 2012/19/EU) which should not be mixed
with unsorted household waste. Instead, you should protect human
health and the environment by handing over your waste equipment to
a designated collection point for the recycling of waste electrical and
electronic equipment, appointed by the government or local authorities.
Correct disposal and recycling will help prevent potential negative
consequences to the environment and human health. Please contact the
installer or local authorities for more information about the location as
well as terms and conditions of such collection points.
Vacuum Cleaner
Multi-Brush Bar
Model Charging TimeVVA1 Approx. 3.5 hours
Charging Voltage
Model AVB9 Model DM002
Rated Voltage30 V 25.2 V
Rated Power
Rated Power Rated Power40 W 20 W
Battery Capacity450 W 2500 mAh
Mini Electric Brush
FAQ
If the vacuum is not working as expected, please refer to the troubleshooting table
below.
Errors Possible Causes Solutions
The vacuum
does not work
The vacuum is out of
battery or low on power.
Fully charge the vacuum,
then continue to use it.
Overheat protection mode
triggered by a blockage.
Wait until the vacuum cools
down, then reactivate it.
The suction opening or
airway passage is blocked.
Clear any blockage from
suction opening or airway
passage.
Weak suction force
Dust cup is full and/or HEPA
filter assembly is clogged.
Empty the dust cup and clean
the HEPA filter assembly.
Attachment is blocked.
Clear any blockage in the
attachment.
Motor is making
a strange noise
Main suction opening or
extension rod is blocked.
Clear any blockage in main
suction opening or extension
rod.
The vacuum
charges slowly
Battery temperature is too
low or too high.
Wait until the battery
temperature returns to
normal, then continue to use
the vacuum.
The first indicator
is red after
turning on the
vacuum
Battery pack is damaged.
Please contact the after-sales
service department for
maintenance.
The first indicator
blinks red after
charging the
vacuum
Power adapter is incompatible.
Only use the original power
adapter to charge the
vacuum.
Battery
indicator does
not light up
while charging
The adapter is not
connected to the vacuum.
Make sure the power adapter
is plugged in properly.
The battery is fully charged
and went into sleep mode.
The vacuum can be used
normally.
If the problem persists after ruling out the above two
possibilities, please contact the after-sales service
department for maintenance.
WEEE Information
To Next Page
Loading...
Need help?
General
