Dreame VVA1 User Manual

10 11
EN EN
How to Use
Function Introduction of Display Screen
How to Use
Cleaning Mode
There are two working modes for the vacuum, which can be selected based on your
own needs.
Mode 1: Discontinuous Cleaning Mode
Press and hold the switch of the vacuum to power it on, and release it to stop
immediately.
Mode 2: Continuous Cleaning Mode (Electronic Lock)
Click the electronic lock key to switch to Continuous Cleaning Mode, and then briey
press the on/o switch to leave the vacuum cleaning in Continuous Cleaning Mode.
Use the electronic lock to free your nger from fatigue caused by holding the switch.
Note:
•
In this mode, briey press the on/o switch to suspend the operation or start
again, and the working mode of the vacuum will not change.
•
Click the electronic lock again to quit the Continuous Cleaning Mode.
Note: If you need to pay attention to any abnormality during the use of the product,
a prompt will appear on the screen. You should follow the instructions on the screen
to keep the performance normal.
Electronic Lock/Reset Filter
•
Click to switch between working modes
•
Press and hold for 1.5 seconds to enter the
lter reset interface
Battery Level Monitor Ring
•
Blue: Battery level is more than 20%
•
Red: Battery level is less than 20%
Gear Switch/Language Setting
•
Click to switch between Eco Mode,
Med Mode, and Turbo Mode
•
Press and hold for 3 seconds
to enter the language setting
interface
Language Settings
Note: If there is no operation for more than 5 seconds, it will automatically exit from
the language setting interface, and the display information will be o.
Set the display prompt language by following the instructions below:
Press and hold for 3 seconds to enter the language selection interface. Click
to scroll through the language list, select a language, and then press and
hold for 3 seconds to save your setting.

Dreame VVA1 Specifications

General

Brand	Dreame
Model	VVA1
Category	Vacuum Cleaner
Language	English