9
ACCESSINGACCESSING
ACCESSINGACCESSING
ACCESSING
(Partition label)(Partition label)
(Partition label)(Partition label)
(Partition label)
When a keypad is loaned to another partition this message will be displayed for
3 seconds. Once the keypad is loaned to another partition, it will function as if it
was a keypad that belonged to that partition. The user will be able to perform all
[✱] functions (e.g. [✱] [7] Door Strike) and disarm the panel using conventional
methods.
EXITING FROMEXITING FROM
EXITING FROMEXITING FROM
EXITING FROM
(Partition Label)(Partition Label)
(Partition Label)(Partition Label)
(Partition Label)
The keypad will return to global mode after 20 seconds of no key presses
made (this time is programmable by the installer). The keypad will also
return to global mode if the [#] key is pressed. This message will be
displayed for three seconds, then the keypad will return to global mode.
Display of Alarms/Bypassed Zones
Your installer may enable bypassed zones or zones in alarm to be viewed
on armed partitions. If so, pressing the [<] [>] keys will display any zones on
the partition that have gone into alarm with the message “View Alarms”
followed by the zone label. Any zones on the partition which were manually
bypassed may also be viewed by pressing the [<] [>] keys.
Note that Home-Away zones which are normally bypassed upon arming the
system will not be displayed.
Auto-bypass/Home-Away Arming
If a correct access code is entered and you do not exit the premises
through a designated exit-entry door, the system will, at the end of the Exit
delay time, arm with interior zones automatically bypassed if those interior
zones have been programmed as “Home-Away” zones. These zones will
remain bypassed until a delay zone is tripped or [✱] [1] is entered to
reactivate bypassed home-away zones.
This is a convenience feature for someone who wishes to remain on the
premises with the system armed. That person does not have to manually
bypass the home-away zones.
If partitions are remotely armed using a global or multi partition access code
i.e. a code that can arm/disarm partitions 1, 2 and 3. The home-away zones
will be active on those partitions except the one being armed from if the user
does not exit through a delay zone.
To reactivate the Home-Away zones that have been automatically bypassed,
press [✱] [1]. This command is a quick method of fully arming the system in
residential applications.
To Next Page
Loading...
Need help?
General
