DocuCutter 545
Programming Jobs
The DocuCutter DC-545 is manually programmable with 80 sets of
available finishing program numbers. An individual set of cutting
dimensions are stored and recalled by a finishing program number.
You may be required to change or add finishing programs
depending upon customer requirements. Follow the steps below to
manually enter a finishing program:
NOTE The information provided here is also available in General
Procedure GP-5 of the DocuCutter DC-545 Field Service Manual. It
is presented in this document for reference purposes only.
1. Power On the DocuCutter.
2. Repeatedly push the <MODE> button until the display indicates
[INPUT].
3. Push and hold the <SET> button until the display appears.
4. Enter the desired program number using the numerical
keypad (01 ~ 80). In this example the program number is 52.
5. Press the [SET] button.
6. Place a PREPRINTED (with a REG mark) sample sheet in the
DocuCutter DC-545.
7. While observing the number on the lower left of the LCD display panel,
push the <+> button until the number changes (a typical change is
approximately 500 to 50, depending on the REG mark position). If the
REG mark goes past the image sensing area, press the <-> button to
move the paper (REG mark) back.
8. Enter the three-digit value from the lower left of the display using the
appropriate key on the keypad. In this example, the value is 52.
9. Press the [SET] button.
10. Remove the sample paper by pressing the <-> button.
11. Measure the distance (in millimeters) between the leading edge of the
paper and the horizontal portion of the REG mark. The value must be
between 5 and 50 millimeters.
12. Enter the value from step 11 using the 10 key keypad.
13. Press the [SET] button.
14. Enter the distance from the left side of the paper to the position for the
left margin slit (LEFT SL) location. This value must be between 0 and
120 millimeters.
15. Press the [SET] button.
16. Enter the distance from the left side of the paper to the position for the
right margin slit (RGHT SL) location. This value must be between 200
and 320 millimeters.
32 DocuCutter 545 Training Guide © 2002, Duplo USA Corporation
To Next Page
Loading...
Need help?
General
