DocuCutter 545
Reasons for JAM and ERROR messages
1. When turning on the power, if any Paper Path
Sensor (PPS1 – PPS4) is blocked, “J1 - REJECT
PAPER” will be displayed.
2. If PPS3 cannot detect the document, after it is fed
10 cm since PPS2 detects it, “J3 - CENTER JAM”
will be displayed.
3. If PPS3 has been blocked, after document is fed its
entire length since PPS3 detects it, “J3 - CENTER
JAM” will be displayed.
4. If PPS4 cannot detect the document, after it is fed
44 cm since PPS3 detects it, “J4 - SLITTER JAM”
will be displayed.
5. If PPS4 has been blocked, after the document is
fed its entire length since the PPS4 detected it, “J4
- SLITTER JAM” will be displayed.
6. If the Upper Blade of the cutter unit does not return
to the home position (the Cutter Position Switch is
not closed) within 400msec since the cutter
movement initiation, “J7 - CUTTER LOCK” will be
displayed.
7. If the Upper Blade of the score unit does not return
to the home position (the Score Position Switch is
not blocked) within 3 seconds since the score
movement initiation, “J8 - CREASE LOCK” will be
displayed.
8. If the covers are opened while the machine is
running, “E1 - COVER OPEN” will be displayed.
© 2002, Duplo USA Corporation DocuCutter 545 Training Guide 39
To Next Page
Loading...
Need help?
General
