DocuCutter 545
DC-545 Theory of Operation
The following describes the DC-545 base model theory of
operation without the AF-100 autofeeder. For details of
the AF-100 theory, see the AF-100 Theory of Operation.
1. The document is placed in the Feed Tray and
PPS1 detects the presence of the document.
2. After 1.5 seconds, the Feed Solenoid drives down
the Input Rollers.
3. After 100msec, the Gate is driven down by the
Gate Solenoid, and the Feed Motor is turned on to
feed the document.
4. Next, the Main Motor feeds the document.
Note: If PPS2 cannot detect the document, after it has
been fed 30mm since feed initiation, “J2 - FEED JAM” is
displayed.
<When using sheet with a Bar Code>
5. The document is fed from the PPS2 location until
the CCD detects the Bar Code.
6. Note: If the CCD cannot read the Bar Code after
the document is fed 50mm, “E3 - BARCODE
ERROR” will be displayed.
<When using a sheet without a Bar Code>
7. After the document is fed 50mm from the PPS2
location, the slitters return to their home positions
and then move to the positions indicated by the
program number.
8. After the slitters are in position, the job is
performed. Go to step 13.
36 DocuCutter 545 Training Guide © 2002, Duplo USA Corporation
To Next Page
Loading...
Need help?
General
