dynabook Satellite C40-J User Manual

Installing the CCD Module
Install the CCD Module according to the following procedures and Figure 4-33.
1. Remove CCD Module release paper.
2. Connect LCD cable to CCD module connector.
3.After ripping off FPC release paste FPC into shell LCD cover.
4.Seat the CCD Module in the correct position.
5.Route the LCD cables according to Figure 4-29, place the cable into the ditch and
correct position. Avoid to pinching the cables.

dynabook Satellite C40-J Specifications

General

Brand	dynabook
Model	Satellite C40-J
Category	Laptop
Language	English