CAUTION: The battery packs contain a lithium ion battery, which can
explode due to improper re placement, use, handling, or disposal. Always
dispose of the battery packs as required by local or dinances or
regulations. Use only replacement batteries recommended by Dynabook.
NOTE: Visually check the battery's terminals. If they are dirty, clean them
with a dry cloth.
Installing Battery Pack
Install battery pack according to the following procedures and Figure 4-9.
1.
Take a new or recharged Battery Pack.
2.
Place Battery Pack in correct position.
3.
Secure Battery with four M2.0x3.5x4.5 black Phillips head screws.
4.
Check the battery screw hole ,if there is cracking, please replace the parts.
5.
Connect Battery cable to CN3 on system board.
6.
Installing Battery Mylar.
To Next Page
Loading...
Need help?
General