12
10-20 secs
21 secs
If you see a solid ‘E’ when trying to use
the appliance, it shows the appliance
has stopped functioning correctly.
Make sure you have checked the following:
The room temperature is above 5°C.
There are no blockages in the inlet grille or loop amplifier outlet.
The filter has been correctly assembled and doesn’t need to be replaced.
The appliance is correctly plugged in directly to the wall outlet.
If the message still displays, unplug and leave for 10 seconds before turning
on again. If the problem persists, please call the Dyson Helpline.
If you see a flashing ‘E’ when trying
to use the appliance, it is unable to do
what has been requested.
Press and hold the ON/ OFF button
on the appliance for longer than 20
seconds.
It is possible to remove your network details from the appliance.
The Wi-Fi symbol will flash alternately between
white and green to indicate that your network
details have been removed.
Wi-Fi can be enabled or disabled by pressing and holding the ON/ OFF button
on the appliance for between 10 and 20 seconds.
Wi-Fi disabled Wi-Fi enabled
If Wi-Fi is disabled, the appliance will not connect to the Dyson Link app.
If you clear your network settings the appliance will not connect to the Dyson Link app.
Flashing
green =
Off =
Flashing
white =
Solid
white =
Enabling or Disabling Wi-Fi
Clearing your Wi-Fi settings
Troubleshooting
Wi-Fi connected
Wi-Fi connecting
Wi-Fi is ready to connect
to your Dyson Link app
Wi-Fi disabled
21.02.2017 15:52 - C84661_HP03_OPMAN_ANZ_ X455_84661.indd_15_4c0s
To Next Page
Loading...
Need help?
General
