7
Air quality below target
• Air quality below target
• Below target room
temperature
• Air quality below target
• Target room
temperature met
Air quality target met
• Air quality target met
• Target room
temperature met
Air quality improving
• Air quality target met
• Below target room
temperature
When auto mode is enabled (indicated by an A symbol in the bottom left corner of the display), the on-board sensors will
intelligently adjust the speed of the appliance according to the air quality.
Auto mode
Appliance is in auto fan mode
Appliance is in auto heating mode
If the air is clean the A symbol will turn green and the numerical display will switch off. If the air quality worsens the A symbol will turn
white and the appliance will automatically restart cleaning the room. While cleaning, the numerical display will show the airflow speed.
Selecting auto mode adjusts the airflow according to the air quality in the room.
For additional control the Dyson Link app can be used to further adjust the sensitivity of the appliance.
A period of 6 days is required after the appliance is first used for the sensor to calibrate. During this period the appliance
may be more sensitive to VOCs (such as odours) than normal.
When auto mode is used while in heating mode, the appliance is both purifying and heating the air. The appliance will display the
target room temperature, not the fan airflow. Once the target room temperature has been reached, the appliance will stop heating the
air. If the air quality target has not been met, the fan will continue to run in order to keep purifying the air. If the room temperature falls
below the target temperature, the appliance will start to heat again.
21.02.2017 15:52 - C84661_HP03_OPMAN_ANZ_ X455_84661.indd_15_4c0s
To Next Page
Loading...
Need help?
General
