Eaton 5P1000RC User Manual

Page 9
5P 750VA-1.5 KVA US_EN
2.4 LCD description
As default, or after 5 minutes of inactivity, the LCD displays the screen saver.
The backlight LCD automatically dims after 10 minutes of inactivity. Press any button to restore the screen.
The following table describes the status information provided by the UPS
Note: If other indicator appears, see troubleshooting on section 5.1 for additional information.
Operation status Cause Description
Standby mode
The UPS is Off, waiting for start- up
command from user.
Equipment is not powered until
button is pressed.
Online mode
The UPS is operating normally.
The UPS is powering and protecting
the equipment.
In AVR mode
1
beep every 10 seconds
The UPS is operating normally but
the utility voltage is outside
normal mode thresholds.
The UPS is powering the equipment
through a Automatic Voltage
Regulation device.
The equipment is still normally
protected.
On Battery
Battery LED is on
1 beep every 10 seconds
A utility failure has occurred and
the UPS is in Battery mode.
The UPS is powering the equipment
with the battery power. Prepar
e your
equipment for shutdown.
End of backup time
1 beep every 3 seconds
The UPS is in battery mode and
the battery is running low.
This warning is approximate, and
the actual time to shutdown may
vary significantly.
Depending on the UPS Load, the
"Battery Low" warning may occur
before the battery reaches 20 %
capacity.

Eaton 5P1000RC Specifications

General

Brand	Eaton
Model	5P1000RC
Category	UPS
Language	English