OPERATION
Eaton 9155 UPS (8–15 kVA) User's Guide S 164201553 Rev G (www.eaton.com/powerquality)
63
Internal Bypass Startup
To start the UPS in internal Bypass mode:
1. If you have an optional MBM/PDM or wall-mounted bypass switch, verify that
the maintenance bypass switch is in the UPS position (see Figure 45 on page 68
or Figure 48 on page 72).
2. If an optional isolation transformer is installed, switch the input circuit breaker to
the ON position.
NOTE When using the optional isolation transformer, Bypass mode is available only for 240V phase-phase
(180° phase angle).
3. Switch on utility power where the UPS is connected.
4. Wait for the front panel LCD to illuminate.
The
indicator flashes.
5. Remove the breaker tie from all battery circuit breakers.
6. Switch all battery circuit breakers to the ON position.
The
indicator stops flashing.
7. Press any button on the front panel display to activate the menu options.
8. Using the
button on the front panel display, scroll to the Control menu option
and press the button.
9. Press the
button to select the Go to Bypass Mode option.
The
and indicators illuminate, indicating the UPS is operating in Bypass
mode. The load is now powered by utility power.
To switch to Normal mode from internal Bypass mode:
1. Press the
button to select the Go To Normal Mode option.
2. Press the
ESC
button until the Eaton logo appears.
Maintenance Bypass Startup
To start the UPS in maintenance bypass (UPS-mounted operation):
1. Verify that the maintenance bypass switch is in the BYPASS position (see
Figure 45 on page 68).
2. Switch on utility power where the UPS is connected.
The load is now powered by utility power.
3. To transfer the load to the UPS, see “Using the UPS-Mounted Maintenance
Bypass Switch” on page 68.
To Next Page
Loading...
Need help?
General
