Eaton 93E60KMBSN User Manual

Eaton 93E UPS 15-80 kVA (380/400/415 V) Installation and Operation Manual
© Eaton Corporation plc 2015. All rights reserved. Revision: 001
Document ID: 614-01975-00
114 (133)
7.4.9 Battery test
NOTE: This UPS has a user initiated battery test intended to determine
if the batteries are able to support the load.
The battery test is only able to be initiated when the battery is fully
charged. This normally occurs
within 72 hours of the start of a charging
cycle. The command will not be shown if the test is not able to be run.
To start an individual UPS battery test:
1. Select the
CONTROLS
symbol in the main menu bar on the UPS to
be tested.
The System Control screen is displayed.
2. Select
Battery
in the System Control screen.
3. In the Battery System Control screen, select the
RESTING
→
TESTING
command and press the push button.
7.4.10 Using the UPS LOAD OFF command
A UPS Load Off is initiated by selecting the
Load Off
command in the
UPS Control screen. The UPS LOAD OFF controls the UPSs output by
powering down the UPS and de-energizing the critical load.
The UPSs (including bypass) remains off until restarted.
To use the LOAD OFF command:
1. Select the
CONTROLS
symbol in the main menu bar on the UPS to
be shut down.
The System Control screen is displayed.
2. Select
UPS
in the System Control screen.
3. In the UPS System Control screen, select the
NORMAL
→
LOAD
OFF
or
BYPASS
→
LOAD OFF
command depending on the UPS
mode, then press the push button.
The Verify Action screen is displayed, providing you with a choice to
proceed or abort the shutdown.

Eaton 93E60KMBSN Specifications

General

Brand	Eaton
Model	93E60KMBSN
Category	UPS
Language	English