Eaton 93E UPS 15-80 kVA (380/400/415 V) Installation and Operation Manual
© Eaton Corporation plc 2015. All rights reserved. Revision: 001
Document ID: 614-01975-00
52 (133)
Secure the UPS cabinet in
position by lowering the
levelling feet until the cabinet is
not resting on the casters and
the cabinet is level.
If you are permanently mounting the system, proceed to Step 11.
Using the retained hardware, reinstall the shipping brackets removed
in Step 2 and Step 5 to the front and rear of the UPS cabinet with the
angle facing outward.
Secure the cabinet to the floor with customer-supplied hardware.
0.
DANGER
Only authorized personnel are allowed to perform battery assembly
and connection to the UPS.
5.3 External power cabling installation
CAUTION
To maintain the product safety and all other design features, make
sure that you reattach all plates and covers removed during the
installation after the installation.
Use cable lugs for mounting the cabling to the UPS power cabling
terminals.
Provide strain relief for the customer cabling. Install a cable gland plate
to the cable inlet used for routing the customer cabling inside the UPS.
NOTE: See Figure 2 through Figure 6 and Figure 22 for the cable entry
points.
To Next Page
Loading...
Need help?
General
