Product information
Introduction
This document provides the instructions for retrofitting an
Eaton‘s Cooper Power™ series CL-7 control panel on an
Eaton, Siemens Corporation, General Electric, or Howard
Industries, Inc. 32-step voltage regulator.
Read this manual first
Read and understand the contents of this manual and
follow all locally approved procedures and safety practices
before installing or operating this equipment. Read and
understand the manuals detailing the installation and
operation of the regulator and the regulator control used
with the regulator. Refer to document MN225003EN,
CL-7 Voltage Regulator Control Installation, Operation,
and Maintenance Instructions for information on the CL-7
voltage regulator control. Refer to document MN225008EN,
VR-32 Voltage Regulator with Quik-Drive™ Tap-Changer
Installation, Operation, and Maintenance Instructions for
information on Eaton‘s voltage regulator with Quik-Drive
tap-changer.
Additional information
These instructions cannot cover all details or variations
in the equipment, procedures, or process described nor
provide directions for meeting every possible contingency
during installation, operation, or maintenance. For additional
information, please contact your Eaton representative.
Acceptance and initial inspection
This kit is thoroughly inspected at the factory. It is in good
condition when accepted by the carrier for shipment.
Upon receipt of the regulator kit, a thorough inspection
should be made for damage, evidence of rough handling,
or shortages. Should this initial inspection reveal evidence
of rough handling, damage, or shortages, it should be
noted on the bill of lading and a claim should immediately
be made with the carrier. Also, notify your Eaton
representative.
Handling and storage
Be careful during handing and storage of equipment to
minimize the possibility of damage. If the regulator kit is not
to be placed into immediate use, store the kit where the
possibility of damage is minimized.
Quality standards
ISO 9001 Certified Quality Management System
1
CL-7 Control Panel Retrofit
InstallatIon InstructIons MN225018EN April 2018
To Next Page
Loading...
Need help?
General
