EasyManuals Logo
Home>Eaton>UPS>Powerware 9355

Eaton Powerware 9355 User Manual

Eaton Powerware 9355
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
UPS SETUP
Eaton 9355 UPS (10/15 kVA) User's Guide S 164201594 Rev D www.eaton.com/powerquality
16
4. Repeat Steps 1 through 3 to remove the vertical bracket on the
other side.
5. Remove the front cover from the bottom cabinet to access the front
shipping bracket.
Press and release the handle latch at the bottom of the cover and
then lift the cover up and off the cabinet.
6. Remove the three M10 bolts securing the rear shipping pad to the
pallet and remove the shipping pad (see Figure 8).
NOTE Hold the back of the cabinet so that the bolts can be removed easily without the
cabinet rolling backward.
7. Remove the two M10 bolts securing the front shipping bracket and
remove the bracket.
If needed, adjust the leveling feet to release the bracket.
Front Shipping
Bracket
Shipping Pad
M10 Bolts
M10 Bolts
Figure 8. Removing the Front Shipping Bracket and Shipping Pad

Table of Contents

Other manuals for Eaton Powerware 9355

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eaton Powerware 9355 and is the answer not in the manual?

Eaton Powerware 9355 Specifications

General IconGeneral
BrandEaton
ModelPowerware 9355
CategoryUPS
LanguageEnglish

Related product manuals