EasyManuals Logo
Home>Eaton>Microphone system>UltraShift PLUS FO-16E318B-MXP

Eaton UltraShift PLUS FO-16E318B-MXP User Manual

Eaton UltraShift PLUS FO-16E318B-MXP
263 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #206 background imageLoading...
Page #206 background image
195
© 2017 Eaton. All rights reserved
2018.12.12
Release Yoke and Cross-Shaft(s) Removal and Installation | Service Procedures TRSM0940
Release Yoke and Cross-Shaft(s) Removal
Note: The Transmission and ECA must be removed prior to
removing the Release Yoke and Cross-Shaft(s).
1. Remove
the upper and lower Cross-Shaft mounting
cap screws and lock washers from the Release Yoke.
2. Remove the
Cross-Shaft Plug with O-ring.
3. Push the upper
Cross-Shaft up out of the Release Yoke
and remove the Yoke.
4. Remove the lower
Cross-Shaft and Release Yoke.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eaton UltraShift PLUS FO-16E318B-MXP and is the answer not in the manual?

Eaton UltraShift PLUS FO-16E318B-MXP Specifications

General IconGeneral
BrandEaton
ModelUltraShift PLUS FO-16E318B-MXP
CategoryMicrophone system
LanguageEnglish

Related product manuals