Chengdu Ebyte Electronic Technology Co., Ltd. E870-W1 User Manual
Copyright © 2012 , Chengdu Ebyte Electronic Technology Co., Ltd.
ASCII configuration custom registration packet, ASCII can be configured up to 6 4B it ).
5.6. Firmware upgrade
The firmware upgrade is realized through the serial port upgrade method, and the device can be upgraded through
the Ebyte serial port upgrade tool
5.7. Hardware factory reset
Restore the factory default parameters. After power on, press the Re load button for 5~10 seconds until all the
LEDs light up ( LINKA&LNNKB only flashes, and the rest of the LEDs are always on until the button is released),
and then release the device to restore the device parameters to Factory default parameters, the device will
automatically restart, short press the device to perform the restart operation.
To Next Page
Loading...
Need help?
General
