STARTER SYSTEM
CS-600
10
2-2 Replacing starter rope
1. Pull out and untie knot (A).
2. Pull knot (B) to remove rope from rope reel (C).
4. Make a knot (D) at end of starter rope and pass
the rope through hole of rope reel, then press the
knot (D) into recess as shown.
D
3. When installing a new starter rope, singe both
ends of the rope to prevent fraying.
5. Pass the other end of starter rope through
rope guide on starter case, then pass starter rope
through starter grip and make a knot as shown.
6. Tighten knot. Push knot into recess of starter
grip.
A
B
C
D
D
To Next Page
Loading...
Need help?
General
