REAR HANDLE AND CONTROL SYSTEM
CS-600
66
9-1 Replacing cushions
1. Remove starter assembly from the unit (Refer to
“2-1 Disassembling starter assembly”).
2. Remove cleaner lid, air fi lter and cleaner case.
Disconnect fuel line, pulse line, throttle rod and
choke knob from carburettor. Remove carburettor
from the unit.
3. Remove three bolts (A).
4. Remove three bolts (B) on the other side of the
unit.
5. Remove collar (C; metal) from intake bellows (D;
rubber).
6. Remove ground lead (E) and the end (f) of pulse
line (F) from the unit.
C
D
F
A
B
f
E
To Next Page
Loading...
Need help?
General
