REAR HANDLE AND CONTROL SYSTEM
CS-600
67
9-1 Replacing cushions (continued)
7. Remove rear handle from the unit.
8. Inspect cushions (G) for cracking or wear. If
damaged, replace with new cushions as follows.
9. To remove cushions (G), pull by hand in direc-
tion of arrows.
10. Apply lithium-based grease on outer surface (g)
of cushion toe, then install cushions by pushing in
direction of arrows.
11. Reassemble ground lead (E) and the end (f) of
pulse line (F) to the unit. Reassemble intake bel-
lows (D) with collar (C) to rear handle.
12. Reassemble rear handle to the unit. Reassem-
ble all related parts.
9-2 Replacing throttle trigger
1. Loosen screw (A) and remove rear handle cover
(B).
2. Inspect rear handle cover (B) and throttle lock-
out (C) for cracking or wear. If damaged, replace it
as required.
3. Push out spring pin (D) from rear handle using
Spring pin tool 897724-01361 (E).
NOTE:
Spring pin will stop before completely
coming off from rear handle, because of effective
length of spring pin tool.
4. Remove throttle trigger (F) together with torsion
spring (G).
G
g
C
A
B
F
G
D
E
g
To Next Page
Loading...
Need help?
General
