37
Using BIOS
Press <Esc> to return to the main menu setting page.
Resume on RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm.
You must use an ATX power supply in order to use this feature.
Init Display First (PCI)
Use this item to select which graphics controller to use as the primary boot devices.
PCI/PnP Setup
This page sets up some parameters for devices installed on the PCI bus and those
utilizing the system plug and play capability.
Help Item
Init Display First PCI
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
PCI/PnP Setup
Select which graphics
controller to use as
the primary boot
device.
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Optimized Defaults
F1: General Help
Press <Esc> to return to the main menu setting page.
ACPI T State (Enabled)
Report processor throttling in ACPI
Intel(R) C-STATE tech (Enabled)
C State: CPU idle is set to C2/C3/C4.
C3 State (ACPIC3)
Nehalem C state action select.
C6 State (Enabled)
Nehalem C state action select.
C1 Auto Demotion (Enabled)
When enable, CPU will conditionally demote C3/C6/C7 requests to C1 based on
uncore auto-demote information.
C3 Auto Demotion (Enabled)
When enable, CPU will conditionally demote C6/C7 requests to C3 based on uncore
auto-demote information.
EUP Support (Enabled)
When enabled, system can not resume by some devices (PCI/PCIE/PME/Ring/RTC,etc)
at S5 state. You can use this item to save power.
To Next Page
Loading...
Need help?
General
