EasyManuals Logo
Home>Efco>Brush Cutter>DS 3500 T

Efco DS 3500 T User Manual

Efco DS 3500 T
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
en
19
WARNING: Never use rigid
blades when cutting in stony
areas. Thrown objects or damaged
blades may result in serious or
fatal injury to the operator or
bystanders. Watch out for thrown
objects. Always wear approved
eye protection. Never lean over the
cutting attachment guard. Stones,
rubbish, etc. can be thrown up
into the eyes causing blindness or
serious injury. Keep unauthorised
persons at a distance. Children,
animals, onlookers and helpers
should be kept outside the safety
zone of 50 ft (15 m). Stop the
machine immediately if anyone
approaches. Never swing the
machine around without first
checking behind you to make sure
no-one is within the safety zone.
WARNING: Never cut when
visibility is poor or in very high
or low temperatures or in freezing
weather.
Starting The Engine
WARNING: When the engine is
started with the choke in either the
choke or start throttle positions
the cutting attachment will start
to rotate immediately.
Place the brush cutter on level ground and
ensure that no objects or obstructions are
in immediate vicinity which could come in
contact with the cutting attachment. Hold
the body of the machine on the ground
using your left hand (CAUTION! Not with
your foot!), see Fig. 15A.
Start-up procedure
1) Slowly push the purge bulb 6 times (9,
Fig.1).
2) Pull the choke lever (15, Fig.1) in the
CLOSE position (A, Fig.15)
3) Pull the throttle lever (18, Fig.1) and stop it
at half-throttle by pressing the button (22),
then release the lever (18).
4) Place the brush cutter on the ground in
a stable position. Check that the blade
is free. Holding the brush cutter down
(Fig.15A), pull the starter rope until the
rst kick over of the engine is heard (no
more than 3 pulls). A new unit may require
additional pulls.
5) Push the choke lever (15, Fig.1) in OPEN
position (B, Fig.15).
6) Pull the starter cord to start the engine.
Once the machine is started, warm up the
machine for about few seconds, without
touch the throttle lever. The machine could
need more seconds to warm up with cold
weather or at high altitudes. Finally, put the
choke lever (18, Fig.1) for deactivate the
automatic half-throttle.
CAUTION:
- Never wrap the starter cord
around your hand.
- When pulling the starter rope,
do not use the full extent of the
rope as this can cause the rope
to break.
- Do not let starter rope snap
back. Hold the starter handle
(14, Fig.1) and let the rope
rewind slowly.
OPERATION

Table of Contents

Other manuals for Efco DS 3500 T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Efco DS 3500 T and is the answer not in the manual?

Efco DS 3500 T Specifications

General IconGeneral
BrandEfco
ModelDS 3500 T
CategoryBrush Cutter
LanguageEnglish

Related product manuals