EFI VUTEk 3r Series User Manual

Introduction
Document ID: OMM-00144-L VUTEk 3r & 5r Series Maintenance Guide 8
Two retaining pins are provided with the printer kit. Operators must install the retaining pins when the printer hood is
open and the operator is performing printer maintenance tasks. Pin installation locations are at the left (LH) and right (RH)
sides of the printer and are installed to prevent the printer hood pistons from closing.
How-to Video:
1. The LH pin installation location is shown in Figure 1-1
.
2. Open the printer hood and insert the retaining pins into the LH and RH pin sockets.
3. Ensure the retaining pins are inserted fully into the sockets, and proceed with any required maintenance tasks.
4. Remove the retaining pins after completing tasks.
1.4 Using Retaining Pins
Warning: The Printer Hood represents a CRUSHING hazard when open. To prevent Operator injury, always
install the Retaining Pins when the Printer Hood is open while performing printer maintenance
tasks. The Retaining Pins are intended for the personal safety of the printer operator to prevent
the Printer Hood from lowering due to operator error or system failure.
CLICK TO PLAY
Figure 1-1 Hood Open, (Left), Installing Pin, (Middle) and Pin Installed, (Right)
Figure 1-2 : Retaining Pin

EFI VUTEk 3r Series Specifications

General

Brand	EFI
Model	VUTEk 3r Series
Category	Printer
Language	English