21
Chapter 3 Advanced Adjustment/Setting
●
Signal Settings
Set the method for outputting the signal input from the PC to the monitor.
Function Setting Range Description
Picture Expansion Auto
*1
Full Screen
Aspect Ratio
Dot by Dot
The screen size of the monitor display can be changed.
• “Auto” The monitor automatically changes the
screen size according to the aspect ratio and
resolution information from the PC.
• “Full Screen” Images are stretched to full screen.
Since aspect ratios are not maintained, images
may be distorted in some cases.
• “Aspect Ratio” Images are enlarged to full screen
without changing the aspect ratio. Since aspect
ratios are maintained, blank horizontal or vertical
borders may appear.
• “Dot by Dot” Displays the image at the set
resolution or size specied by the input signal.
Note
• Example settings
- Full Screen
- Aspect Ratio
- Dot by Dot
*1 Only enabled when input signal information according to which the setting can be automatically
determined is detected during HDMI input
Function Setting Range Description
Sharpness 2 to -2
When a low-resolution image is displayed in “Full
Screen” or “Aspect Ratio” mode, text or lines in the
displayed image may be blurred. This function reduces
this blurring effect.
Note
• The sharpening setting may not be required
depending on the display resolution. (“Sharpness”
cannot be selected in such cases.)
To Next Page
Loading...
Need help?
General