If after some tries the burner does not
light, check if the crown and its cap are in
correct positions.
WARNING!
Do not keep the control knob pushed for
more than 15 seconds. If the burner does
not light after 15 seconds, release the
control knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
CAUTION!
In the absence of electricity you can
ignite the burner without electrical device;
in this case approach the burner with a
flame, turn the control knob counter-
clockwise to maximum gas supply
position and push it down. Keep the
control knob pushed for equal or less
than 10 seconds to let the thermocouple
warm up.
If the burner accidentally goes out, turn
the control knob to the off position and try
to light the burner again after minimum 1
minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut. It
is normal.
The hob is supplied with the progressive
valves. They make the flame regulation
more precise.
5.3 Turning the burner off
To put the flame out, turn the knob to the off
position
.
WARNING!
Always turn the flame down or switch it
off before you remove the pans from the
burner.
6. HINTS AND TIPS
WARNING!
Refer to Safety chapters.
6.1 Cookware
CAUTION!
Do not use cast iron pans, clay or
earthenware pots, grilling accessories or
toaster plates. The stainless steel can
become tarnished if it is too much
heated.
WARNING!
Do not put the same pan on two burners.
WARNING!
Do not put unstable or damaged pots on
the burner to prevent spills and injuries.
CAUTION!
Make sure that the bottoms of pots do
not stand too close to the control knob,
otherwise the flame heats the control
knob up.
CAUTION!
Make sure that pot handles are not
above the front edge of the cooktop.
14 ENGLISH
To Next Page
Loading...
Need help?
General
