WARNING!
Pay attention not to damage the gasket.
Do not use sharp tool to remove it.
4. With a thin screwdriver, adjust the bypass
screw position (A).
5. If you change:
• from natural gas G20 20 mbar to liquid
gas, fully tighten the bypass screw in.
• from liquid gas to natural gas G20 20
mbar, undo the bypass screw
approximately 1/4 of a turn.
6. Reassemble the gasket, the washer and
the knob.
WARNING!
Make sure to place the gasket exactly in
the original position.
WARNING!
Make sure the flame does not go out
when you quickly turn the knob from the
maximum position to the minimum
position.
3.6 Electrical connection
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug
(if applicable).
• The appliance must not be connected with
an extension cable, an adapter or a
multiple socket. There is a risk of fire.
• Do not let the power cable to heat up to a
temperature of more than 90°C. The cable
should be guided by means of clamps
fixed to the side of the cabinet, in order to
avoid any contact with the appliance
beneath the cooktop.
• Make sure that there is access to the
mains plug after the installation.
Electrical Requirements
Permanent electrical installation must agree
with the latest I.E.E. Regulations and local
Electricity Board regulations. For your own
safety the installation must be done by a
qualified electrician (e.g. your local Electricity
Board, or a contractor who is on the roll of the
National Inspection Council for Electrical
Installation Contracting [NICEIC]).
ENGLISH 9
To Next Page
Loading...
Need help?
General
