x
Declaration of Conformity
Manufacturer’s Name:
Control Techniques
Manufacturer’s Address:
12005 Technology Drive
Eden Prairie, MN 55344
USA
Declares that the following products:
Products Description:
E Series Digital Servo Drive
Model Number:
EN-204, EN-208 and EN-214
System Options:
This declaration covers the above products with the ALP-130 Backup
Logic Power Supply and ECI-44 Screw Terminal Interface.
Conforms to the following product specification:
Electomagnetic Compatibility (EMC):
EN 55011/1991 Class A Group 1, CISPR 11/1990 Class A Group 1
EN 50082-2/1995: IEC 1000-4-2/1995; EN 61000-4-2, 4kV CD
IEC 1000-4-3/1995; EN 61000-4-3, ENV 50140/1993, 80% AM, 10V/m
@ 3 m
IEC 1000-4-4/1995; EN 61000-4-4, 2 kV ALL LINES
IEC 1000-4-8/1993; EN 61000-4-8, 30 A/m
ENV 50141/1993, 80% AM, 10V, .15-80 MHz
ENV 50204/1995, Pulse, 900 MHz, 50% DTY, 200 Hz
Supplementary information:
The products herewith comply with the requirements of the Low Voltage Directive (LVD) 73/23/EEC and EMC Directive
89/336/EEC
This electronic drive product is intended to be used with an appropriate motor, electrical protection components and other
equipment to form a complete end product or system. It must only be installed by a professional assembler who is familiar
with requirements for safety and electromagnetic compatibility (“EMC”). The assembler is responsible for ensuring that
the end product or system complies with all the relevant laws in the country where it is to be used. Refer to the product
manual for installation guidelines.
December 2, 1997
Bradley Schwartz/ VP Engineering Date
European Contact:
Sobetra Automation
Langeveldpark Lot 10
P. Dasterleusstraat 2
1600 St. Pieters Leeuw, Belgium
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General