10
U.L. Model No.: CF244 & CF252
Do not install any light bulbs into the light kit plate if
using the cover plate. Installation of light bulbs when
using the cover plate could result in fire, shock and
serious personal injury.
WARNING
!
1. Place the cover plate onto the lower housing aligning
the three flat areas on the top flange of the cover
plate with the three pins on the inside of the fan
motor housing assembly (Figure 17). Then turn the
cover plate clockwise until it stops turning.
2. Your cover plate is now installed
General
Your Emerson Ceiling Fan/Light Remote Control
consists of hand-held transmitter and a receiver which
is mounted under the fan ceiling cover. The remote
control is designed to separately control your ceiling fan
speed and light intensity.
The remote control transmitter is powered by two AAA
alkaline batteries (included). To prevent possible
damage if the batteries should leak, be sure to remove
the batteries when the control is not to be used for an
extended period of time.
Code switches in the transmitter and receiver may be
set in 32 different positions. If your fan and light go on
and off without using your control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems. To
remedy this situations, simply change the combination
code in your transmitter and receiver.
Preset Memory Feature
Your Emerson receiver is equipped with a preset
memory feature. If the AC supply to the receiver is
powered through a wall switch, when the switch is
turned OFF, the control will remember the light intensity
and fan speed. When the switch is turned back ON the
light and fan will resume operation as they were prior to
the switch being turned OFF.
How to Assemble Your No Light Cover Plate
Remote Control Procedures
To Next Page
Loading...
Need help?
General