13
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF244 & CF252
Trouble Shooting
WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
TROUBLE SHOOTING YOUR FAN.
!
!
!
TROUBLE PROBABLE CAUSE SUGGESTED REMEDY
1. Fan will not 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or
start. circuit breakers.
WARNING: Make sure main power is
turned off.
2. Loose power line connections to 2. Check line power connections to fan.
the fan.
3. Fan/Light Remote Control is OFF. 3. Turn ON Fan/Light Remote Control.
2. Fan sounds 1. Blades not attached to fan. 1. Attach blades to fan before operating.
noisy.
2. Screws securing fan blades to motor 2. Check to make sure the screws which attach
are loose. the blades to the motor are tight.
WARNING: Make sure main power is
turned off.
3. Loose screws in motor housing. 3. Check to make sure all screws in motor housing
are snug (not over-tight).
3. Fan wobbles 1. Setscrews in motor coupling are 1. Raise coupling cover and tighten setscrews
excessively. not tightened securely. securely.
2. Setscrew in the hanger ball/downrod 2. Tighten the setscrew in the hanger ball/
assembly is loose. downrod assembly.
3. Screws securing fan blades to motor 3. Check to be sure screws which attach the fan
are loose. blade to the motor are tight.
4. Fan blades are not seated properly. 4. Check to be sure that the screws securing
the fan blades seat firmly.
5. Hanger bracket and/or ceiling 5. Tighten the hanger bracket screws to the outlet
outlet box is not securely fastened. box, and/or secure outlet box.
6. Fan blades out of balance. 6. Interchanging an adjacent (side by-side) blade
pair can redistribute the weight and
result in smoother operation. Or use supplied
balancing kit to balance blades.
4. Both lamps will 1. Loose electrical connectors. 1. Shut off the branch circuit electricity at the
not illuminate. fuse box or breaker panel and check the
receiver electrical connectors for proper
installation.
2. Remote control battery is weak. 2. Replace the AAA remote batteries.
3. The lamps are burnt out. 3. Turn the electricity off and replace the lamps
with new 50W max. lamps.
4. Lamps turn on and then turn off. 4. The built in circuit breaker is tripping, check that
the lamps are each 50W maximum.
CAUTION: Turn the lights off before touching
halogen lamps, they are very hot and can
burn your fingers.
To Next Page
Loading...
Need help?
General